Ahh, as some of you might know ive tried to make some corvette tail lights by just painting over the tail light panel and that didnt work out too good. The lines were getting in the way and paint got under the tape i laid out and... it got ugly lol. So what im going to do next is get a circle attatchment to hook onto a drill and make some holes in my tail lights. Then i will bondo it all up. Then go to maybe autozone and get some circle tail lights to put inside of the tail light assembly where i had cut the circles.

Of course its a little hard to imagine but i know exactly how im going to do this. However im at college right now so look back around thanksgiving because thats when im going back!

In addition to the tail lights, im thinking about an aftermarket BMW E36 headlight swap. I was a member at v6z24.com for a long time and those guys know how to make their cars look good :) Well they discussed a BMW 3-series headlight swap onto their cars and it fit with quite a bit of modification. Since my headlights are square like theirs are then im pretty sure i can make it fit. Along with getting a 9003 headlight harness and splicing it in, i wont have much of any problems.

As far as engine upgrades, all i want are bolt on upgrades such as newer intake plenums/lower intake manifolds, a 58mm TB, and possible newer heads for overall better flow. As far as forced induction or work on the bottom end i say nay to that because of the fact that these 3.3's are built like a rock and im too lazy and broke to replace all that lol. Additionally i dont want to put any unnecessary stress on the car (forced induction). Maybe in the future once it gets me through college i might think about it but its doing me fine right now.

Oh one more thing, I also plan on adding a FUNCTIONAL hood scoop and molding it in. This will mount right over the plenum and im hoping to get enough clearance to run an aluminum pipe for my intake to the hood scoop to sit the filter in there nice and cool.