FLIP-FLOP TRUNK PICS:
THIS WAS THE WAY I DID MY TRUNK SINCE I"M A WELDER /FABRICATOR, FIRST I CUT 4"X1 1/2" FLAT BAR, WELDED IT TO BOTH SIDES OF TRUNK HINGE WITH FLAT WASHERS AS SPACERS ITS 1" APART, THEN DRILLED 1/2" HOLES COMPLETELY THROUGH BOTH SIDES, USING 3/8"X2 3/4" BOLT AS THE SWIVEL PIN. ONCE AT SHOW TAKE OUT FACTORY BOLT THAT CONNECTS HINGE ARM TO TRUNK LID, PRESTO, IT SWIVELS DOWNAND SITS ON THE SIDE WALLS OR TO MAKE IT SIT HIGHER I JUST PUT MY 4WAY LUG WRENCH IN THE GROOVES.
