ok a friend on mine broke a cotter pin that held the shock in place and i had to replace a bolt and cotter pin here are more pics and i replaced the cotter pin with a steel pin
new subs and new amps
1000 watts 10" SPL subwoofer
Cast aluminam basket
gray stone finish w/diamond cut edge
cloth laminated paper cone / MPG coating
Zinc coated CNC back plate
low Carbon top & pole piece
large foam rubbor, high excursion surround
1 piece rubber gasket
sensitivity 87db
Freg- resp: 28Hz- 2kHz
magnet 160oz
3" Dual 4 layer 1ohm voice coil
gold- binding posts
mono channel operation
full mosfet circuitry
3 way protection circuitry
selectable lpf, flat crossover
50Hz - 250 Hz low pass filter
selectable bass boost @50Hz
50db channel seperation
90db signal nose ratio
22k ohmimput impedance
200 mV-2V imput sensitivity
(i have to sell these so i can get other things done)
