Page 4

I started working on my car again a couple of months ago. Here is the recent progress.

I ordered new sections of both rear frame rails. Here is the new one on the passenger side.

When I cut into the drivers side of the rocker panel I found out it was too rusty. I fabricated the outside piece first and then the inside. Then I welded in the new front spring hanger.

I welded in a pre-fab piece of frame cap from Auto Rust Technicians and then welded in the drivers side frame.

I finished tacking in the rear shock x-memeber tonight. After I install my rear x-member it will be time for the trunk pans.