Vehicle Owner

Member ID: Delay_FTB

Location: Chandler, AZ

Vehicle Info

1999 Toyota Camry

Bragging Rights

  • 1/4 Mile0 sec @ -1 mph
  • 0-600sec
  • Top Speed-1mph
  • HP-1
  • Weight-1lbs

Major Upgrades

  • turbo
  • nitrous
  • bore increase
  • port and polish
  • supercharger
  • extrude honed
  • stroke increase
  • engine swap

Modifications

Performance Parts

Car Audio & Video

Ratings

    • Currently 3.0/5 Stars.
    • Currently 3.0/5 Stars.
    • Currently 3.0/5 Stars.

Login to rate

 

Last updated: Aug 22, 2005

Hits: 2,379

Josh’s Toyota Camry
“Alexandria”

  • Currently 2.96 /5 Stars.
3 guestbook comments

Page One - Stock Pics & Basic Info
Page Two - Equipment
Page Three - Removals and Gutting
Page Four - Sound Deadening and Misc. Pics
Page Five - Tutorials
Page Six - Stuff...

Rear Seat and Deck Removal----------------------------------------------------------------------------------------------------------------------

Rear Bench:---------------------------------------------------------------------------Rear Bench Clips:

Pull up on the front of the bench, behind the driver and front passenger seats (not in the center). A strong pull should remove the clips from their secure position:

Seat Side Trim:----------------------------------------------------------------------------Seat Side w/o Trim:Delay_FTB's 1999 Toyota Camry

Seat Belt and Trim Bolts:Delay_FTB's 1999 Toyota Camry------------------------------------------------Seat Belt and Trim Bolts (Upclose):Delay_FTB's 1999 Toyota Camry
Remove two lower bolts (seat belt and trim) and retract the seat belt and remove the seat side trim. There is also another bolt holding down the center belt, be sure and get that one too.

Actual Pillar------------------------------------------------------------------------Pillar Cover (Backside)
Delay_FTB's 1999 Toyota Camry Delay_FTB's 1999 Toyota Camry
Take out pillar covers for each side of the car.

Fold down rear seat backs.

Unclip (from the trunk area) the plastic box-like thing in the center of the rear deck, near the window. Also, while in the trunk, looking up at the deck, you should find a couple of plastic panel retainers that should be removed as well.

Delay_FTB's 1999 Toyota Camry


Then remove the seat belt trim holders, and slide the rear deck cover out of place.

Plastic Trim Behind Folding Seats (Passenger Side):Delay_FTB's 1999 Toyota Camry-------Plastic Trim Behind Folding Seats (Driver Side):Delay_FTB's 1999 Toyota Camry
Unscrew the plastic screws that hold the panels into place, and remove the trim pieces.

Lastly, you will need to unbold the seat backs. On each side there should be a bolt...

Delay_FTB's 1999 Toyota Camry


Unscrew these, and also there should be a few bolts under the seats, near where the center seat belt was bolted down. Remove those bolts (Its a pain, but doable) and with some help, remove the seat backs. At this point, your entire rear deck should be, for the most part, empty.

Delay_FTB's 1999 Toyota Camry

---------------------------------------------------------------------------------------------------------------------

Page One - Stock Pics & Basic Info
Page Two - Equipment
Page Three - Removals and Gutting
Page Four - Sound Deadening and Misc. Pics
Page Five - Tutorials
Page Six - Stuff...

Guestbook

Displaying entries 1-3 of 3

anshu  

Posted by: anshu

06/17/2005 11:30PM

mine was just labeled amp turn on

anshu  

Posted by: anshu

06/07/2005 03:04PM

nice cam, good infoz, check me out

lucanhookup  

Posted by: lucanhookup

06/03/2005 07:41PM

hey wat up. i made my eyelids using vinyl. im working on blacking out some clear coners right now. should be hot...lol.....when i put my 19's on i had to roll the rear fender a bit cuase the tire rubbed on a lil lip it has but thats all i had to do to make them fit.......peace

Show Older Comments

Post a comment

Bookmark this Ride

Vehicle Owner

Member ID: Delay_FTB

Location: Chandler, AZ