Posted by: JCKim1988

08/01/2005 08:57PM

Yeah, it will fit.

Posted by: civic200719972

07/31/2005 11:15AM

yea, if theres not a hole where the emblem was, just buy some sticker remover, but if there is a hole, your gonna have to take peice of sheet metel and weld it on the inside, then take and grind arond the whole, also make sure its sanded real well, then mix up some bondo or fiberglass and put on it, and sand the contour into it, it aint that hard lates

Posted by: 04Quick_Silver

07/20/2005 08:28AM

thats cool well their not the only ones with a by pass vavle but if you wannt spend the money its cool. well what i had to do is that the adaptor it came with to fit with my MAF (mass air flow sensor) the holes where off set from the ones on the adaptor cause the adaptor is made for the ser and spec v or w/e so i went to autozone to see if i could find an adaptor that was like made for my MAF but i found one for older verson sentra like 98's or something so i got that and it was the same thing just made of a thinner metal so i just lined it up markd it and drilld like a few extra holes. then the other thing is you have to run the pipe threw that hole in you fender, and it has to be made about an inch bigger or so. so i just ....(cough) hit it with a stronger piece of metal and it bent easly how i wanted it. and if you read the instructions it says to take off your front left wheel and jack the car up but i got it so i have a screw and bolt holdin on one of the bottome covers so all i do is unscrew it and pull it down so i can reach the air filter ...you'll figure out why...just easier to take it apart and put it together....goodluck with it and keep me posted

Posted by: 04Quick_Silver

07/16/2005 11:32AM

yeah man thanks for the comment, i was lucky enough to find me a set of weapon R headers on ebay and it came with the cross pipe the thing is i still havent put it in cause the whole thing about my parents no knowing about it....but they go in soon, till then i am gonna put a nitrous kit in myself in the next few days though...the only modifcations i had to do to those headers was i got two of those holes filld up cause they where for another O2 sensor and a smog sensor. good luck with your car, peace

Posted by: Poltergeist_2k5

05/23/2005 08:05PM

Hey nice ride to answer your question about my performance muffler. i didnt have to replace any piping altho i did later replace some piping because it was old and rotting.