I kinda feel like I need to start a new page for the seat install. you would think that something as simple as installing a set of seats would be easy, but no.
I don't know how other camaro guys do it, and I wasn't about to spend the money to buy the unversal set if I have a set of working sliders on my old seats, so....
these are the steps I took
1.Cut these tabs out of a sheet of metal
2.Drill holes in the tabs, I know this looks very inprecise, but i had to measure all these parts a dozen times.
3.I then tested out where the tabs should be on the old sliders to adapt the new seats
4.I tack welded the tabs in place, and trial fit the tracks on the seat, and in the car.
5.Suprisingly everything fit perfect, I guess u do mesure twice and cut once! So I then fully welded the tabs in place
6.Painted them balck so they would look batter than factory...
7.Finally the final product, about to bolt them down...
a look from the side, you can see the 5 points coming up.
And finally a look from the other side.
NEW SEATS READY TO SLIDE!
Hope this helps someone
