OK OK OK... well I haven't updated in a VERY long time. Mainly because I have been RE-DOING a whole lot.
So let me fill in what I have been up to...
It all starts with getting yet another wiring harness... This time it mounts in the trunk. A nice way to clean up under the front dash.
Here is what you get.
This is the panel that the fuse panel will be mounted to. It is welded to one of the roll cage bars.
Guage panel chilling on the roof as the wires get ready to fill the car!
The initial placement of the massive amount of wires. Let me tell you, it is at least 10-20 lbs of wire. There is a ton of it. Dont mind the bleach water botle back there. hehe.
Let the sorting begin!!!
My best attempt to organise a custom guage set up. I guess you can call it plug and play now...sorta.
Here is my 3 switch panel. I had to dremel 2 of these covers to get the push buttons under there. From left to right it is
PURGE-N20 arming-BLEACH
New headliner off ebay. Nice for about $180. Much better than stock, it is mounted to a piece of ABS plastic. very tough.
The interface from the Painless harness and the custom panel
Next more motor pics!!! Finally getting done with it.
