I took the seats and center console out of a 1993 Chev ext. cab. After re-workng and customizing the stock brackets I made them bolt to my trucks uneven floor(I had dual gas tanks). I also had to make a pedistool for the center console to sit on so it would sit flat and at the right hight for the seats. I bent the pedestole out of sheet metal and then covered it with black felt. Once the console is on it you cant see it. The seats and console fit perfectly into my truck.

I am in the process of installing the air bags right now. I will have more photos as the install progesses.

This is the center console with my air gauges installed into the bottom of the cup holders. The console will also hold the ten switch box I am going to put in. I then shopped and found a dash pad that was in near mint condition. With the door handles shaved on the outside I had found no reason to have them on the inside too.

My ulpolhster and I custom made new door panels that only house the power windor buttons. The rest it blue and white leather. With the door panels completely smooth the only problem is that there is nothing to grab when you want to close the door(minor). Every part of the interior was replaced. New carpets and floor mats with the bow tie embroided in them. The back of the cab and floor was insulated with trunk mat before the carpet was layed down. The headliner and behind the seats is all white leather.

I have a floating headliner with the same stitching as in the seats(the design is mirrored fromt he center console).

The seats are blue leather with white inserts only in the top. All the interior and stitch work was done by Heart Ulpohstry of Aldergrove,B.C

To finish off the interior I added a Colorado Customs steering wheel and some billet on the instrument cluster and on the passenger side of the dash. This picture is of the dash with out the billet over for the instrument panel, I'll have some more photos soon.
Here are some more photos of my interior

This is a plaque I had made up for my girlfriend, its on the passenger side door sil.
I am in the process of making a new fibreglass center console that'll hold my two audiobahn tens and the gauges.

I started on it in december but it was two cold to do any fibreglassing. I am going to have to wait till summer to start on it again. I will be posting more pictures of it as I get around to doing something on it. From the pictures you can see the speaker rings, that will be where the subs will be mounted. They will be mounted in reverse with the magnets sticking out.

The audiobahn tens that will be mounted in the fibreglass center console.