SIRX90

Just helping out w/ the probe GT swap into the mx-3.

Purpose:
-School project car
-Needed car with little bits of body damage, so when i attend Penn State College Of Technology i have something as a class project. I can then turn around and sell it when im done or keep as a second car. I accepted car as payment for favor i did for friend.

Single cam motor didnt work so the saga began. I'll be posting pictures here as i move along with this project.

I also have an 92' Integra that will be gettinga bit of work here and there. Check it out sometime.
http://www.cardomain.com/memberpage/689461

---------------------------------------------------------------------------------------------------------------------
The "To do list" in no order:

-Finish dropping motor.DONE
-Mask off and paint engine bay black.DONE
-Start gathering parts for LS/B20 swap.STARTED
-Make mounts for seats.
-Bend custom or buy new exhaust.
-Spray WingsWest side skirts & bumpers, roof & wing Gloss Black.
-Install kit and wing.
-Install new windshield.
-Make Air duct through bumper or hood for air intake.
-Take seat belt coils out of door.DONE
-Buy new radiator.
-Design and fabricate a rear section roll cage.
-Paint windshield wiper arms and faded window trim black.
-Install new passenger side fender.
-New stock front bumper, and make a lip out of fiberglass or rigid plastic.
-Install motor. Finito!!!!

PAGE 1- uhh durr..
PAGE 2- Engine work
PAGE 3- Interior shit
PAGE 4- Making the bad less of an eyesore.