k8 ecu questions.
Alot of people swap in the KLZE motors into the mx-3. Something to remember is, not all k8 ecus can be chipped. Only certain ones can. What I need to know is the eprom number inside your ecu. In the picture here is where the chip is at.
First take off the 4 phillips screws on top. Then there are like 4 or 5 more holding part of the ecu in. Take out those, and then flip up the board and look for the eprom with a sticker I circled it in red in the picture below. I need those numbers. the last 4 digits mainly. If it starts with a 16** it CANNOT be chipped. Example would be in the picture that one cannot be chipped. If it starts with like a 2*** it CAN be chipped.
Hope this cuts down on the confusion. Feel free to email me at probegtze@hotmail.com If you have further questions.
If you would like to order a chip for the k8 it will be 35 shipped if within the states 45 if outside the states. Expect delay if outside. the post office has about a 8-12 business day delevery time.
paypal is probegtze@hotmail.com make sure to state if you have a curve neck or straight neck ze in your mx3.
