Updated at page 4! Check it out!
New info on page 3!

Sitting in garage, lurking.....

New recepie!

* Engine: 355 cui
* Intake: Performer intake
* Heads: Performer RPM, fully ported..
* Carb: Edelbrock Performer 750 cfm (retuned)
* Fuelpump: Carter Street
* Camshaft: 268' CompCams hyd, flattappet (256 intake, 268 exhaust)
* Rockers: harland sharp roller
* Pushrods: CompCams Magnum
* Ignition: Mallory HEI recurved (all in by 2400 rpm's).
* Headers: Flowtech with double 2.5 inch exhaust.
* Transmission: 350 TH with shiftkit
* rearaxel: locking (positraction?)
* Gears: 3.08
* Likes: Gas and full throttle runs!
Eating Ricers!

The odd looking swede driving and building the car =)

Backview of 2Slow

New Heads Edelbrock Performer RPM 60899
Ported!
2.02 intake, 1.6 exhaust. Guideplates etc etc. comp cams springs (972 outer and 973 inner, TO STIFF!)

Lunati Springs that will be used instead: 73084

New Springs installed in heads.

Single Spring_______________1.450'' OD
Description_________________Single w/ Damper
OD__________________________1.450''
ID__________________________1.080''
Seat Load,Height/Load_______1.750''/115
Open Load, Height/Load______1.250''/250
Coil Bind___________________1.080''
Max Lift____________________0.610''
Rate________________________270 lbs

Harland Sharp rollers on Parade!

Yes here they are!

Edelbrock!

Fully Ported Exhaust

and fully ported intake of course!

Yummy!! Yummy!! Yum Yum Yum... =)

Carter Street mechanical pump!