Interior Shots:
Stainless Steel gauge faces. The previous owner "redmx591" worked with MiataDesign to produce them :)
What it looked like when i first bought it in july.
What my interior used to look like in october with red vinyl.
Side shot c/o teamabsolute. taken at xtreme nationals. and yes, i won a trophy! woohoo.
COMPLETELY new interior shots: YES, I DID IT MYSELF. here's what regular fabric looks like on the dash/doors/center console box and shift boot :P
Center console box. Wasn't easy trying to make it fit tightly to the lid so it would close properly. After an hour, it worked!
Stainless vent rings, HVAC panel, shifter suround, A/C Knob, Powdercoated sparkly voodoo shift knob, and fabric shift boot.
Good crease shot. Kinda hard to shape it around that contour, but it was worth the 2 hours *rolls eyes*
Cut a hole where the vent goes, folded under taut, and put stainless vent rings on. Tucked in nicely around the dash.
Little piece. By far, one of the most difficult pieces to put fabric on. After i molded it around the outside end (as you can see, had to fold along the edge) i cut the fabric in half at the gauge box, and lined it up even. Can hardly tell.
Pardon the mess. Took these pictures while at work since it's the only daylight i had all week. This is basically what it looks like now.
Tucked under the rubber for the window. Another difficult and very time consuming part. rather than cutting up to the rubber, i cut JUST beyond it, and tucked it in there with the dull side of an exacto knife. since the material wasn't as thick as the vinyl i originally had on there, it wasn't as hard as i predeicted.
