The engine stuff is purchased and being installed. Parts are listed below. Block was bored .060 over, heads cut for bigger valves, and heads milled to accept double valve springs. Im going to port and polish the heads.
- Manley Race-flo 2.02 intake valves
- Manley Race-flo 1.60 exhaust valves
- Summit Racing Cam 234/244 @ .050 lift, .520/.544 lift
- Summit Racing chromemoly pushrods
- Crane Cams Valve Springs (110/320 lbs pressure)
- Crane Cams retainers and keepers
- Comp Cams double roller timing chain
- Speed Pro flat top pistons (9.5:1 comp)
- Gaskets, bearings, plugs, rings, oil pump
- Moroso oil pan and pickup
- Edelbrock Performer RPM air gap intake manifold
- Edelbrock 750 carburetor
- MSD 6AL ignition box
- MSD Billet distributor
- Summit high-voume water pump
- Summit harmonic balancer
- Aluminum Flywheel
