If your looking to get parts powder coated ~~>CLICK HERE NOW !!!

this page is under construction::

I havent spent to much time working on the exterior of the car. I have been dealing with engine bay and interior.

puting the trust FMIC on now time to pull and powdercoat the piping.

at 1.bar this was fun to drive
this was my interior when i first picked her up. where do i start

well i have all that taken care of

first thing i did after the engine bay fire was ported and coated the manifolds

added this 3" exhaust,smoked the tails and marker signals

i waited 2 months to get these babies in

OK i blew it now its time for a full upgrade .

cleaned and resurfaced to get the grooves out for a sure compression seal.
noticed there a few more dowl pin holes in there over stock along with them perty ports i cant wait to here this motor
i cant wait until im back on the road with her again.

im sure ill see some good power out of this
but its been months and this is where i walked away.

This is a list of mods i have completed to date. and still trying to keep it street dressed

black 88 t2 with full rebuilt j-spek motor & tranny,
Itto's large street intake/exhaust port,
new rotor bearing were also installed along with a 3 window bearing port,
all synchros replaced, harden gears used
ALS Apex seals 2MM,
93+ solid corner seals,side seals etc,
upgraded oil pellet,
4 extra dowl pins added,
coolant passage porting,
under hood powder coating,
C's short shift,
Dual guage pod with boost and air/fuel gauges,
no heat or ac,
no power steering,
no emissions,
smoked tails and signals,
K2RD block off plates,
Gilmer pulley kit (WOW),
16" E fan,
Microtech LT8s & LT10s
battery relocated,
apexi BOV & Blitz BOV
Garret to4 70IN / 83AR turbo upgrade,
greddy cast EX manifold,
Innovative PRO GATE WASTEGATE 42mm
HKS intake
Innovative LT1 Wideband
ACT 6 puck clutch,
taylor 10.4mm wires,
Knight Sport FCD,
3" TID intake with cone filter,
Greedy throttle body intake,
throttle body ported,polished and modified,
powder coated intake manifolds and mixed pieces under the hood,
ported uim & lim manifolds,
Trust front mount intercooler,
3" full exhaust off Bonez 2.5" DP,
walbro 255 fuel pump,
720cc primary 1600cc secondary
Paxton FPR with gauge,
Braided fuel lines,
Braided Oil lines,
Braided clutch line,
RE amemiya mirrors
16" 5 star rota's in silver,
17" JDM red enkei's racing S,
stupid grant steering wheel

next 
tranny bag
2x 1.lb *fire* EXTINGUISHER !!!!!
role cage
5 point harness
CO2 setup
water injection
3" radiator
KYB AGX and RS*R race springs
Braided brake lines
GP Sport body kit
M Sport fenders
M Sport steering wheel
new carpet
MAZDASPEED pedals
red bride seats
BF Goodrich g-force TA
deep black with 6 coats of clear

MY LITTLE ROTOR HEAD IS HERE:: I HAVE A GIRL:: BORN SEP. 3/04 JUST FINE::