Vehicle Owner

Member ID: Trek91

Location: bsb, BN

Vehicle Info

2003 Mitsubishi Outlander

Bragging Rights

  • 1/4 Mile0 sec @ -1 mph
  • 0-600sec
  • Top Speed-1mph
  • HP-1
  • Weight-1lbs

Major Upgrades

  • turbo
  • nitrous
  • bore increase
  • port and polish
  • supercharger
  • extrude honed
  • stroke increase
  • engine swap

Modifications

Performance Parts

Interior

  • A'PEX Gauges 
  • Recaro Seats 

Exterior Styling

  • Yokohama Tires 

Car Audio & Video

Ratings

    • Currently 3.0/5 Stars.
    • Currently 2.5/5 Stars.
    • Currently 3.0/5 Stars.
    • Currently 2.8/5 Stars.
    • Currently 2.5/5 Stars.

Login to rate

 

Last updated: Dec 21, 2006

Hits: 16,762

dean’s Mitsubishi Outlander
“Trek91”

  • Currently 2.98 /5 Stars.
27 guestbook comments

Page One

Trek91's 2003 Mitsubishi OutlanderApexi RSM, Apexi S-AFC II, Ralliart Drop-IN Filter, Ralliart Radiator cap 1.3, Ralliart Thermostate 71 deg, FuelSave , Ground Cables, Ecotek,Carmaniafront top struts,4 point lower stabilizer bar,center n rear lower struts ,Pivot Raizin Volt Stabilizer and just replace my front end with Turbo version

Trek91's 2003 Mitsubishi Outlander

Had a Major FaceLift, notice the difference

Trek91's 2003 Mitsubishi Outlander

Installed Carbon Hood ..Sweeeeettt!!!!

Trek91's 2003 Mitsubishi Outlander


Trek91's 2003 Mitsubishi Outlander

Installed a extended rear top spoiler

Trek91's 2003 Mitsubishi Outlander


Trek91's 2003 Mitsubishi Outlander

EcoTek, The CB-26P, pictured is a maintenance free mechanical device that can be universally fitted to almost all petrol engines.It works by creating turbulence in the inlet manifold thus improving the combustion process; this means that it reduces emissions, improves fuel consumption and maximises engine performance

Trek91's 2003 Mitsubishi Outlander

2nd generation S-AFC (Black Display Limited Edition)is a fuel computer that adjusts fuel/air ratio by modifying the air-flow meter/MAP sensor signal. The S-AFC features a user-definable, eight-point, adjustable fuel curve that can be set in 500 RPM increments. The range of fuel adjustment is +/- 50% at each of the user-defined setting points. On hot-wire vehicles, the Deceleration Air Flow Correction function is capable of curing the erratic idle and stall problems associated with open-atmosphere blow-off valves on hot-wire air-flow meter systems. The S-AFC is capable of monitoring and replaying the following data channels in Numerical, Analog Meter and Graph displays: Intake Manifold Vacuum/Boost Pressure, Air Flow Capacity, Intake Manifold Pressure, Karmann Frequency, Engine RPM, Throttle Position, and Air Flow Correction %

Trek91's 2003 Mitsubishi Outlander

Apexi Rev Speed meter measures a vehicle's engine RPM, speed, and distance traveled. In addition, it displays battery voltage (in real time) in three different modes: numerical, analog, and graphical. Peak values are also displayed in all three above-mentioned modes, and playback can be displayed graphically. It can measure the speed acheived & the time elapsed in 0-100m. 0-200m, 0-400m runs, and vice versa, it can measure the time elapsed for 0-100km/h, 0-200km/h, & 0-300km/h. In addition, with time taken to acheive a vehicle's top speed, intermediate acceleration can be measured. It records & stores the 5 best values of each function. Turning the power off will erased all values recorded if not stored in memory. (Stop watch readings are erased when power is turned off)

Trek91's 2003 Mitsubishi Outlander

Rockford 10" Bass Tube run by Rockford 250M amp 10" woofer with FIBERLock cone rugged Roto-Mold enclosure frequency response 40-125 Hz handles 200 watts RMS/400 watts peak sensitivity 87 dB 15"W x 24-1/16"L x 10-13/16"H

Trek91's 2003 Mitsubishi Outlander

My newly installed Recaro SRII seats....

Guestbook

Displaying entries 1-5 of 27

stutzedward  

Posted by: stutzedward

11/10/2009 04:06AM

WOW, I like the CF food. Keep up the good work!

Syaim  

Posted by: Syaim

03/06/2009 11:46PM

nice bro.good job.come see my ride bro.pls gv comment ya

dmeluzio22  

Posted by: dmeluzio22

03/29/2008 09:41AM

Great pics still. I added a few pics from a small Mitsubishi Endeavor meet and thought it was cool that we had 3 cars there. You guys have tons!
-Derek

dittylopez  

Posted by: dittylopez

08/01/2007 12:13PM

Awesome ride! I hear of these "conversion" kits and would like to know more about them. I was wondering if the bumpers, sideskirts and fenderwell flares are interchangable with an Outlander? How bout the engine and performance parts. I own an 06 but don't have it in my cardomain garage. I'd appreciate any info you that any reads this can provide! 5*!

dirtydeeds98  

Posted by: dirtydeeds98

11/20/2006 03:19PM

I just bought a 03 Outlander & man if I could get a conversion kit to get it lookin like that I'd b bustin nutts every time I look out the window @ it!

Show Older Comments

Post a comment

Bookmark this Ride

Vehicle Owner

Member ID: Trek91

Location: bsb, BN