HOW-TO: DTEC & AEM UEGO Wideband working together
first, youll need to get the GREEN analog wire from TurboXS..i believe its around 35$. plug it into the last empty lot in the brain. if you have the DTEC FCBC...ignore all this since it will not WORK.
-connect it the white analog wire coming off the AEM WB. for NGK users...i believe it is the brown wire. solder and electrical tape it please so all readings are correct.
now from the main menu go to setup/calibration
go to AUX
enter and under Label 1....type AFR
scroll down a little bit...and enter these into the settings.
Gauge Major Div - 3
Gauge Minor Div - 5
offset (%) + 0.00
display damping 20
CLICK NEXT PAGE.
you will now be in CALIBRATIONS
Gauge min (%) +10.00 (set this to w/e is the lowerst your wb reads)
Gauge Max (%) +17.00 (set this to w/e is the max your wb reads)
Gauge Number DP 2
Gauge Multiplier x10
Digital Number DP 0
Cal 1 input (mV) 0 (put this to 1, if your WB is a 1-2v reading
Cal 1 output (%) + 10.00
Cal 2 input (mV) 5000 (this is the max mV your wb goes to. if its a 1-2v reading...put 2000 here)
Cal 2 output (%) + 20.00
now your done. save this to your brain
now enable to ON
***NOTES***
*in setup/calibration chanel 5...AFR...ignore it, this channel is soley for the TXS wb.
*you will have 2 AFR guages on your gauge mode. one will not work. the other will read from 1.00 to 1.70 if done my method.
**LOGGER MODE WILL NOT WORK for the AFR... it will read --.-- under AFR. ignore it
***you will need to use dash mode if you wish to view all your variables as well as be able to Datalog w/ the AFR mode ENABLED.
Thanks to christian! (a.k.a. mikeymoe) on SRTForums.com for figuring this out.
SWITCHING ACTIVE FUEL MAP
EDITING MAPS
SELECTING ACTIVE MAP
The Map with the <-Active indicator
is the active map which the Dtec -FC
will use for its calculations for
modifying the amount of fuel.
The Dtec-FC allows 4 separate fuel
maps. To change the active map,
move the cursor up to Active Map
Selection and select the option by pressing A.
At the Edit Active Map window, choose which map you wish to make active and select it by pressing A. To
confirm the selection by press A again, otherwise press B to abort the new selection.
