Return to Table of Contents
Updated Dual Electric Fan Install
Wiring Electric Fans:
My FLX-210 fans are setup to my requirements. 1 fan on full time w/ ignition on ACC or car running. The other fan is on when A/C is utilized.
1. I gain ACC power off the green wire on the harness shown below. I use the black ground wire on that harness too. Not sure what the blue & yellow ones are for:
2. Connect the other fan's power line to the lowest rightmost fuse relay::
Remove the bus. Push out the 2 small tabs that run parallel to the fender and pull entire black bus. Turn bus over to expose the underside:
3. The blue/green runs to the low fan relay. I used to use that one but then the A/C fan stopped working so I'm using the blue/orange.
4. Run that wire directly to fan power line.
