Close

Forgot password?

Log In | Join Now

Vehicle Owner

Member ID: FuelSlut6Litre

Location: Allen Park, Michigan

Vehicle Info

1989 Chevrolet Camaro

Bragging Rights

  • Weight3200 lbs

Major Upgrades

  • extrude-honed
  • bore-increase

Ratings

    • Currently 3/5 Stars.
    • Currently 3/5 Stars.
    • Currently 3/5 Stars.
    • Currently 3/5 Stars.

Login to rate

 

Last updated: Dec 17, 2005

Hits: 5,706

George Allard’s Chevrolet Camaro:
“G2G12S”

  • Currently 3/5 Stars.
32 guestbook comments

If you have ANY questions... on any parts I used or anything about them, please do not hesitate to email me for help, I firmly believe in learning from other people's mistakes, as well as accomplishments, this project is a little from column A and a little from column B... if you catch my drift.

Parts List For 1989 Chevrolet Camaro’s 355cid., 1 Piece Rear Main, Internally Ballanced, 10:1 CR, MPFI Engine (thats right, pump gas!)

COMPANY / PART / DISCRIPTION / PART NUMBER (differs from dist. : summit, jegs, overchargers etc.)

• Streetdampr / Fluidampr / 6 Ύ” , Internally balanced FLU-716242
• TCI / Flexplate / 168 Teeth, Internally balanced, SFI approved, Dual bolt pattern TCI-399773
• Holley / StealthRam MPFI system / 30 pph. injectors, 58 mm Throttle body (+) HLY-91504201
• Pete Jackson / Gear Drive / “Quiet” Gear drive PJJ-350-91C
• Crane / Camshaft / Hydraulic roller, 234/242 duration @ .050”, .539”/.558” Gross CRN-109841
• March / Pulley Set / Aluminum, 3 pulley kit (crank, alternator, & water pump) MCH-4010
• Crane / Lifters / OE, Hydraulic Roller CRN-10530-16
• Trick Flow / Cylinder Heads / Twisted Wedge G2, 2.02/1.6”, 67cc, Dual Springs TFS-31500005
• Trick Flow / Pushrods / 4130 Steel, 5/16” diameter, .080” thick, 8.050” long TFS-21408050
• Trick Flow / Rocker Arms / 1.6 ratio, 3/8” stud, roller tip TFS-31400511
• Trick Flow / Pistons / Forged 4032 Aluminum, 4.030” bore, .927” pin., float CR, 1.55”CH TFS-31504000
• Speed Pro / Piston Rings / .030”, top = 1/16, 2 = 1/16, oil = 3/16 SLP-R9902030
• MSD / Distributor / Pro Billet, Single Pickup, HEI Small cap MSD-8366
• GM Performance Parts / Fuel Pump Block Off Plate / Bow tie, chrome 022141210
• ARP / Engine Bolt Kit / Polished stainless steel, hex head ARP-534-9601
• ARP / Oil Pan Studs / Stainless steel, hex head ARP-434-1901
• Milodon / Timing Chain Cover / Polished aluminum 740S6040
• ARP / Balancer Bolt Kit / Ό” washer, 5/8” hex head ARP-134-2501
• Mr. Gasket / Valve Cover Gaskets / Neoprene, Steel 72566001
• ARP / Head Studs / 12 Point ARP-134-4301
• Energy Suspension / Motor Mounts / Polyurathane 2113-1116G
• Mr. Gasket / Water Neck / Chrome 72566210
• Mr. Gasket / Thermostat / 160 degree 2624363
• Tavia / Timing Pointer / 6 Ύ” Adjustable, Fluidampr 911TAV2350
• Milodon / Oil Pan / Passenger side dip stick, stock replacement 6qt. MIL-30702
• Milodon / Oil Pan Gasket / 1 piece, rubber-steel MIL-41001
• Milodon / Windage Tray / Diamond Stripper MIL-32250
• Summit / Drain Plug / Magnetic SUM-G15
• Eagle / Crankshaft / 4340 forged, int. balance, 1 pc. Rear seal, 3.750” stroke ESP-435334805700
• Eagle / Connecting Rods / 4340 forged, H-beam, 5.7”, large journal ESP-5700B3D
• Melling / Oil Pump / High volume, standard pressure M55HV
• Melling / OIL Pump Drive Shaft / Steel, steel sleeve IS55E
• Melling / Pickup / Larger orfice 55S1
• ARP / Flexplate Bolts / Internal balance, 12 point, 7/16” ARP-100-2901
• Mr. Gasket / Wire Dividers / Billet, 7-8 mm. SBO/6018
• GM Performance Parts / Valve Covers / Polished aluminum, tall PRO-141-108
• Powermaster / Starter / XS torque, 4.4:1 GR, 200ft.-lb., 168 tooth PWM-9500
• Summit / Vacuum Reservoir / Steel SUM-G1464
• Summit / Vacuum Gauge / Black SUM-G3125
• MSD / Ignition box & Rev Limiter / 6 AL with built in soft touch rev limiter MSD-6420
• MSD / Spark Plug Wires / 8.5 mm Super Conductor (red) MSD-31239
• DEI / Plug Wire Boots / High temp. (red) DEI-010522
• Auto Lite / Spark Plugs / Specified by trick flow (used only for initial break-in) 3924
• Milodon / Water Pump / Team G, aluminum SBC standard rot. 09258241
• March / Power Steering Bracket / Polished Aluminum, serpentine 74420125
• March / Alternator Bracket / Polished Aluminum, serpentine 74420165
• Holley / Colling Fan Relay Kit / “add-on” to commander 950 system 310534-134
• Fel-Pro / Intake Manifold Gasket Set / Specified by Holley 2151205
• Fel-Pro / Head Gaskets / Specified by Trick Flow 2151010
• Powermaster / Alternator / One wire, 140 amp, serpentine, chrome 63637294
• Earl’s Plumbing / Fuel line / braided 3ft. long, -6, o-flex (2) 403006
• Earl’s Plumbing / Reducer / -6 to 16mm – 1.5 991955
• Earl’s Plumbing / Reducer / -6 to 14mm – 1.5 991954
• Earl’s Plumbing / 45 deg bend / Auto-fit, -6 45deg. 304606
• Earl’s Plumbing / 90 deg bend / Auto-fit, -6 90deg. 309106
• Earl’s Plumbing / Straight / Auto-fit, -6 (2) 300106
• Milodon / Dip Stick / Braided Stainless Steel MIL-22005
• Fel-Pro / Header Gasket / Specified by Trick Flow FPP-1404
• Stage 8 / Header Bolts / Locking Style, stainless steel STG-8911

Exhaust-
* Edelbock TES tri-y headers + y-pipe, the AIR tubes have been chopped off and welded over and the headers have been coated black by exotic coatings
* Quick-Time Performance 3inch electric exhaust cut-out
* Spintech Cat-Back muffler, 3inch in 3inch out
* Mandrel Bent 3inch pipes from y to muffler, and 3inch downspouts off muffler

Gauges-
* auto meter phantom speedo (160)
* auto meter phantom tach
* auto meter phantom air/fuel ratio
* auto meter phantom fuel level
* auto meter phantom trans temp
* auto meter phantom water temp
* auto meter phantom volts
* auto meter phantom oil pressure
(under hood, summit racing vacuum gauge)

700r4 (1989)built by...myself -
* 13 vane pump upgrade
* hardened pump rings
* .005 boost valve (upgrade)
* 5 pinion front and rear planetaries
* TCI pro kit (complete kit, seals, rings, clutches bands etc. (the works)...9 check balls came out, 2 went back in...sounds bad, but trust its not!
* 1 qt. deeper Derale pan (with cooling tubes)
* haynes trans cooler
* hardened sun shell (w/laser weld ring)
* upgraded servo
* 29 element sprag
* B&M mega shifter
* B&M 3400 true stall holeshot torque converter (lock-up w/ anti-ballooning plate)
* auto meter trans temp gauge

Suspension & Drive -
* KYB AGX adjustable Shocks & Struts
* Eibach Pro Kit Spings
* Spohn Front & Rear Sway Bars
* Spohn Adjustable Torque Arm (Comes With Trans Crossmember w/ built in Drive Shaft Saftey Loop)
* Spohn Sub-Frame Connectors
* Spohn Lower Control Arms
* Spohn Lower Control Arm Relocation Brackets
* Spohn Panhard Bar
* Spohn Extreme Duty Driveshaft
* R1 Concepts Front and Rear Slotted + Cross-Drilled Zinc Plated Rotors
* Hawk Racing Front and Rear Brake Pads
* Earl's Plumbing Braided Brake Lines
* Moog Front End Rebuild Kit w/Spohn Heavy Duty Tie-Rod Adjusters
* Moser 12-Bolt rearend, c-clip eliminators, 33 spline axles & perf. cover
* Eaton 4.11 posi unit
* BF Goodrich Drag Radials
* Zoops Power Steering Pump
* Zoops Power Steering Resivor
* Zoops Power Steering Bracket
* Zoops Power Steering Pulley (Serpentine)
* SSBC Electric Vacuum Pump

Stereo -
* Pioneer Head Unit (CD/WMA/MP3)
* Pioneer 3-way 4x6's (2)
* Pioneer 4-way 6.5's (2)
* Pioneer 5-way 6x9's (2)
* Pioneer 2inch tweeters (2)
* Kicker 850x2 Amplifier
* Kicker Comp CVR 12inch subwoofers (2)
* Q-Logic custom kick panel enclosures
* Dobek's Dad custom sub-box

Bookmark this Ride

Vehicle Owner

Member ID: FuelSlut6Litre

Location: Allen Park, Michigan