Page 1: Updated Pics 08/04/04
PAGE 2: You are here
PAGE 3: 2003 Honda Accord Tips
PAGE 4: Painted Side Mirrors, Top Weather Canal, and OEM Side Skirts
PAGE 5: Installation of Koni Front Adjustable Shocks
PAGE 6: Mod List
PAGE 7: 2003 Accord Wire Layout

DIY CLEARED HEADLIGHT ASSEMBLY

**Turn on you lights and mark the highest point that you light make on the wall**

**This is because you may have to re-align your headlights afterwards**

expand

Remove the plastic locking things at the locations shown above. I just used a flat head screwdriver and slightly pryed them off.

There's also more underneath the car. Just follow the bumper. Then there is 1 screw on each side of the front fenders.

After you get the top part off and the side screws and the ones in the bottom...your ready to pull the bumper off. They snap in place right under the headlight assembly. Don't worry you don't have to pull too hard. It'll just snap right off. Then it'll look like this..

expand

Now your getting closer to removing the Headlight Assembly.

expand

expand

There's 6 bolts total that needs to be removed (All of which uses a 10mm socket). Then it just pulls right off. Disconnect all the lights and take the Headlight Assembly someplace where you could pry it open.

First remove the bracket that holds the bumper and the Headlight assembly to the car.

expand

I had my wife help me on this part. Grab a flat head screwdriver and start prying

expand

Use a heat gun to loosen up the sticky gasketting. As you are prying it more and more use a razor to cut it, to keep it from sticking back together as much.

When you get it open you have to remove a phillips head screw that holds the Plastic chrome piece that has the amber on it

expand

As soon as that's off, slightly bend it. This will make little amber piece stick up a little (Enough to use a flat head screwdriver to pry it out)
**This is also a time to paint it Black for Black Headlight Housing!!!

expand

**Before putting it all back together, make sure to wipe down fingerprints or any smudges on the Headlight.. you don't wanna have to open them again!!
Then just put everything back together. A tip when you put the headlight assembly back is to use some pliers to squeeze it back together so that way it'll make a good seal.

expand

After everything is put back.. you're gonna have to realign you headlights up or down.

expand

**Clear Out Headlights at your own Risk! I will not be liable for any damage or injuries to yourself or vehicle**

I also installed the Front Chrome Grille

expand

and I finally installed the Coilover's and the Camber Kit (SPC Camber Kit #60145)!

expand

expand

-Made ghetto Super White Bulbs, by writting blue lines on a Clear bulb using a blue sharpie.. Works ok until it burns off every week or so (Then I have to rewrite the lines again) LOL :oP

-RIMS!! 19's from www.selecttire.com

expand

-Neuspeed Tie Bar Polished P/N: 35.20.58P at www.tornactive.com

expand

Page 1: Updated Pics 08/04/04
PAGE 2: You are here
PAGE 3: 2003 Honda Accord Tips
PAGE 4: Painted Side Mirrors, Top Weather Canal, and OEM Side Skirts
PAGE 5: Installation of Koni Front Adjustable Shocks
PAGE 6: Mod List
PAGE 7: 2003 Accord Wire Layout