process of changing paseo steering wheel into my AE85: This is original steering from behind
This is paseo one
As u can see the AE86 [on top] connection ring for the horn is smaller then the paseo one (bottom)
I figure out aluminium can is the best here cuz I was drinking coke and I put the the can right on the ring area(what happen next, keep on reading)... it is hard,light weight and good conductor.
so I measure it and cut, don't forget to use send paper to take away the paint and plastic
this is the ring for bottom
install it on the bottom of the ring
so I tried..failed..there was 0.7mm different to connect to the ring from the connector.(small and golden shinny one)
so I place the bottom of the can drink on it, same process cut and send paper
lucky perfect in size
Done =) Oh don't forget to put enough 1/2 solid lob on it..if not u can hear gez~gez~ sound on it.

and also U need to change from low beam to high beam.. because the steering wheel is flater and smaller. so what u should do after is change the wire which connect to the head light. it take longer process if u change from the dash area....so I use the easiest... there are 1 green(top)and blue(right). opposite them .... whole process finish..

I'm done
my hand made emblem