HPI Savage SS Nitro 4WD
This is my first Nitro car (truck), but I finally put it together, and can't wait to put it to good use!
Some Modifacations:
Proline Big Joe Tires on RAMtech 40 Series Sidewinder Rims
Hitec 5945 (steering) & 5625 (Throttle/Brake)
Airtronics MX-3 Transmitter & Receiver
HPI Reverse Module w/ JR 527 Servo
HPI Stainless Dual Disk Brake Kit
Mugen 3 Shoe Clutch
HPI High Flow Air Filter
4 Gear Spider Diff Mod w/ Silicon Diff Oil - Front 30,000wt & Rear 50,000wt)
Ofna Pirate Servo Saver
Throttle/Brake Mod
Ofna 1400mah 6v Hump Pack
Dual Tank Mod
Venom Fail Safe
GPM 3mm Center Skid Plate
She bought it! :-)
Dual Tank Mod: HPI braces off the bottom of the differential were bolted to to the stock shock towers with 4-40 Stainless Steel threaded stock (which replaced the 3mm bolts), and tie wraps to hold the tank in place. The additional two pieces in the middle were added for strength and to reinforce the aluminum HPI braces (which bend up pressure).
Savage Stand - It only cost me $14.99 in Plumbing Supplies @ Home Depot!
The "Temp" Work Station!
The Two Money Pits! ! !
