Going for the roll cage this week.I'll try to get some pics of install and final assembly.
Finally got the cage here are the pics. Did'nt have time to take build pics and it's not yet painted but here it is.
Got some CROW 3" 5 point harness on the way.I'll install those soon.
Well it has been some time since my last update,but at the same time progress has been slow.Work is taking a lot of free time I used to have but here are some updated pics of work in progress.
6/5/05
This is the new brake system.Master cilinder and proportioning valve from wilwood,brake lock from Biondo, and all lines and fittings from earl's
As you can see on these I have stitch welded the whole front end.I've done other trick stuff to the suspension but I'll keep that hush for now.
These are of the front end with the JAZ 1 gallon fuel cell.
These are the two puppies that will take care of the fuel and air mixture.50mm WEBER simplicity at its best.
And these....Well they speak for themselves.
For those few who have kept up I appologise for not continually updating the page, but qwik update the chassis is finally complete and the motor is in and started. Will be dynoing soon will have pics, HP and TRQ numbers soon. Expect to compete in all California events next season of 2006.
3/29/06 Well bad news is that the motor blew from lack of oil pressure which was not caught till too late, motor gave out at about 8700 rpm, so it took out the block, main girdle, rod and piston, head chamber one and four, and crank all due to pressure loss from a bad oil pump. Did not expect to be building the 1.8 so soon but building another ZC is just not cost effective. So back to the drawing board. This SUCKS!
