Vehicle Info
Bragging Rights
- 1/4 Mile12.8 sec @ 120 mph
- 0-604.5 sec
- Top Speed155 mph
- HP290
- Weight2790 lbs
Major Upgrades
- turbo
- engine swap
- bore-increase
Modifications
Performance Parts
- Custom Intake
- Custom Exhaust
- Wiseco Engine Comps.
- Custom Perf. Chip
- Custom Engine Electronics
- Custom Springs
- Custom Transmission
Car Audio & Video
Interior
Exterior Styling
NEWS: I am considering selling the flyin4, need something with roof racks and a towball i can leave in dodgy places and not have to worry about, as i have a new toy now.
will probably advertise it for $15000 Australian dollars.
if anyone is interested, let me know in the guest book.
I just installed a bosch 040 fuel pump, its a 500hp unit.
The engine rebuild finished, but not yet dyno tuned for power.
Soon the car will be back on the road with the following parts:
GT30R garrett turbo.
XSPower Stainless steel manifold.
Turbosmart Evolution 40mm wastegate.
4inch cold air intake with k&n pod filter.
Forged wiseco pistons 0.5mm oversize.
Forged eagle conrods.
Balaced crankshaft.
Reconditioned Head.
Cometic head gasket for 8:1 compression.
ARP head bolts.
Kaaz 1.5 way Limited slip diff.
Extreme brass button clutch.
New CV joints and driveshafts.
I am customising the tail lights - see image at bottom of this page.
They are painted now, they look awesome.
The much awaited dyno run will be coming soon.
what sort of power figures will be seen?
Will there be more torque than before?
How much boost can the fuel system handle?
Check back soon for details.
Whiteline suspension Australia offers some nice handling mods for the camry, might pay them a visit in the near future...
1 - a 5s-fe in a celica ( 2.2L camry motor) standard, exhaust and exhaust plus extractors.
2 - the power graph of my 3S-GTE motor on 9psi vs 13 psi before rebuild and above mods.(old engine setup - see pics)
3 - The power and torque of the motor on 13 psi before rebuild and above mods.
1
2
3
The car made 138Kw(177Hp) and 345Nm of torque on 9psi
and 157Kw(211Hp) and 420Nm of torque on 13 psi with no new mods except the boost controller which apart from allowing more boost, allows it to spool up the turbo quicker for more boost earlier in the revs giving more power and torque.
also the boost doesnt taper off in the top end.
New dyno graphs soon after the engine is fully run in.
The engine bay pic shows the custom intercooler piping, Blow off valve and colour matched head, all welds have been sanded out already except for the pipes showing through the kit, may get that done soon.
on the right is the new setup with new turbo, wastegate, manifold, downpipe etc.
note this motor is not the one used in american mr2's only in japan, it is rated at 245PS or 241Hp as standard, not bad for a 1996 motor considering a new WRX STI makes only 19Hp more and runs 16.5 psi through its 2L boxer motor as standard.
-17' by 6.5' chrome Vault rims.
-235 by 45 falken ZEIX tyres at the rear.
-235 by 45 falken azenis semi racing slicks on the front.
-Lowered lovels sports springs.
-GFB boost controller.
-GFB stealth BOV.
-HKS type 1 turbo timer/g tech meter.
-Red shift light (ebay)
-2L turbo motor (3S-GTE) with colour coded yamaha head.
-Front mount intercooler and custom piping.
-3 inch Dump pipe.
-3 inch flex.
-3 inch hi flow cat convertor.
-3 inch exhaust split to 2 2.5 inch exhausts at the back.
-2 cannon mufflers.
-3 inch Cold air intake pipe from front of kit.
-camry air box with K&N panel filter.(gone)
-3 inch feed from air box to turbo. (4inch now)
-Stinger 4 channel ECU (aftermarket computer for fuel, timing,ignition, rev limiter, no speed limiter, and dyno tuning)
-Full shogun body kit.
-Moulded WRX bonnet scoop (fully functional to keep engine cool).
-Moulded rear wing.
-Ford Blueprint paint.
-Clear aftermarket front blinkers.
-Clear aftermarket front headlights and corner lights.
-Clear side blinkers off a 2002 holden commodore.(straight fit, no mods needed)
-Removed badges.
-Chrome blue mesh grill at front.
-removed arial.
-colour coded everything.
-Autotecnica steering wheel, gearknob and gear boot.
-Blue racing pedals.
-Custom made parsley tray (12 mm mdf) with blue vinyl covering
-3.5 inch shortened gear stick.
-Blue neons in boot and under the dash. (gone for now)
-Blue interior blinkers
-Blue instrument cluster lights.
-Blue dragon floor mats
-Blue NOS seat covers
-Custom Blue vinyl lining in boot (by me)(still being finished off)
-new mechanical boost guage.
-Sony Xplode 208 watt dual display deck
-Sony Xplode 350 watt 3 way 6 by 9s
-4" alpine 2 ways in front (80W)
-Fusion 4 cannel amplifier 200 watts rms for speakers
-sony class d monoblock amp, 600W rms @ 2 ohms.
-2 Sony xplode 1300W 12' Subs in genuine sony boxes. pics soon.
-Fusion wiring kit.
-Rampage wiring kit.
-Spray on sound deadening through entire trunk, and in all doors, over 8 750ml cans of the stuff, easy, cheap and effective.
latest project: custom taillights
this is computer generated, i will match the paint and use pinstriping aroung the edge ot the paint.
Special Thanks To:
Theos Automotive
Turbologics
Driveline Gears
Oskars Smash Repairs
My Family and Friends
My beautiful and Patient Girlfriend.
Bookmark this Ride