INDEX
Pg 1...Mods to date
Pg 2...General pics
Pg 3...Body Kit/Exterior
Pg 4...club pics
Pg 5...TEC3 install
Pg 6...Suspension, Koyo slimline rad
Pg 7...Boss Frog Clearview
Pg 8...Stuff for Sale
Pg 9...The Good, The Bad, and The Ugly...and the Beautiful
Pg 10...Coolant Re-route
Adding a body kit
Racing Beat Type II nose & Type I rear wing
VIS Racing side skirts and rear bumper
custom intake duct on driver's side headlight lid
Paint stripped off!
VIS Side skirts too short!
Major hacking required:
Day 5...lotsa work, but fibreglass/bondo does wonders!
VIS side skirts nicely molded to proper radius of wheel well and along "groove" at mid-height of car
Day 6...ready for primer!
Crookedness of BSP duals now more obvious....gotta fix that!
Sorry, RB, but the imprinted logo is tacky...
Day 8...primered and sanded....ready for paint
Finished! :)
Overall, the job was well done. There are a few smudges on the stripes, front and rear, right where the midline groove is, since the tape was apparently hard to keep down in the small radium of the groove. The stripes were apparently a major PITA to paint on, because of all the parts to measure and make everything line up properly.
The Racing Beat Type I wing sits too low and the edges hit the top of the fenders, so I need to add another ~1/8" gastket to raise it up higher off the trunk lid.
The grills in the front and back were cheaply and quickly put into place. Currently, it is black, "square", chicken wire material, but I will be putting in some better diamond shaped mesh.
The BSP duals look even more crooked now, so that will be next in line to be fixed.
INDEX
Pg 1...Mods to date
Pg 2...General pics
Pg 3...Body Kit/Exterior
Pg 4...club pics
Pg 5...TEC3 install
Pg 6...Suspension, Koyo slimline rad
Pg 7...Boss Frog Clearview
Pg 8...Stuff for Sale
Pg 9...The Good, The Bad, and The Ugly...and the Beautiful
Pg 10...Coolant Re-route
