This page is about how I installed the lights into the nostrils of my RAII hood. It only took a little bit of work, and the bulbs work with my parking lights, and turn signals. I like the way they look, and it helps makes it a little different.
First I cut off the back of two extra parking lights that I had, just the part where the bulb fitting screws into it... and I took that piece and bondo'd it to the middle existing hold in the hood.
Then I cut the wiring of the sockets out of an extra tail light wiring harness I had, so I had two sockets that would fit and lock into the pieces that I just bondo'd to the hood. I wired them up to my parking lights, and to both turn signals.
Then I drilled holes up the side of the hood through the under-layer, and ran wire ties to keep the wires all together up the side of the hood, and it was all good to go!
