This page is going to show most of the parts being replaced to go with this swap.
I have received my Q45 VLSD differential + 4 axels.

Sold my gto fuel rail covers,I replaced them with the corvette one's.You could see them installed, I need to modify the fuel line for the left side to fit.And the dipstick had to be bent a little too for the right side.

I ordered some parts today 10/4/05.
Here is the list of parts:5" ultralite 200mph speedo,
5" ultralite memory 10rpm tach,2 5/8 autolite oil pressure,
2 5/8 autolite water temp, and 2 5/8 73 ohms empty-8/12 ohms full autolite fuel pressure.
willwood bigbrake kit from arizona z car.I have to use a camaro oil pan,tray, and pick up.
I still need to order lots of thing this week.
Yesterday (10-5-05) I ordered John's Car Kit,And a set of mooser axels from modern motorsports.Today (10-6-05)I will order a custom grind Camshaft - 228"/230" .576"/.595" 114LSA
This weekend I should pick up my mustache bar and a set of adapters needed for the q45 diff swap.
And the list goes on,I should upload pictures very soon.

My brakes just arrived.

Mustache Bar With some letter engraving.

This are the adapters needed for the q45 diff swap.

Here are the guages going in my dash.

John'S Car's Kit arived today.This is the kit you need to install the LS1 LS2 engine in your Z.

The mooser axels are here.Arrived 10/18/05

A set of Supension Techniques Sway bars!

Aeromotive Fuel Pressure Regulator.

79 to 81 280ZX Master Cylinder.

Service books Manual for the 05 GTO.

Oil pan,tray and pickup,From a 2002 camaro.

I was going to go with a 90mm Fast Throttle Body,And add a mecanical cable to open it with the gas pedal.
Plans have changed,I'm kepping the orignal Drive by wire TB.In order to use this,I had to get the original gas pedal from the GTO.