The next part was some prep work for later. Another trip to the steel yard and to tractor supply and I spent about $50 on steel and hardware to build a body lift kit, installation of this comes later and I'll also explain later why this is such a crucial part of my design. Here's how they were made though, The van requires 14 of these spacers. The outer pipe is 3" OD, the inner pipe is 2 3/8" OD, both are cut in 2" lengths and the small one is placed inside the big one. This could have been accomplished with thicker wall pipe or larger dia washers but this is what I had to work with that was easy to get. The large washers had the OD I needed but not the ID so I had to weld a smaller washer to the large washer to get my desired OD and ID then I welded the washer assemblies onto the pipe assemblies ultimately making 3" dia by 2 1/4" long spacers.