Here is the system. It was started on Sept 26, 02 and finished on May 7, 03!
PAGE 1 ----INTERIOR shots
PAGE 2 ----SYSTEM shots
PAGE 3 ----Night neon shots
PAGE 4 ----ENGINE bay/process
PAGE 5 ----Trophies/Car shows
PAGE 6 ----My other car
PAGE 7 ----EXTERIOR SHOTS
PAGE 8 ----GIRLS and my car
PAGE 9 ----My friends cars
PAGE 10---ZX2 PhotoMagic
PAGE 11---Free Wallpapers
PAGE 12---My other project car
PAGE 13---My ZX2 at Hot Import Nights
Page 14---My ZX2 at World of Wheels
Page 15---NEW LAMBO DOOR CONVERSION!!!
New police siren install!!
More secret buttons!
Switch, gauge, and deck installation
Backseats and interior gutted and rough templates are made for the basic stereo setup.
Structural supports, capacitors, distribution blocks, and wires are ran.
Amps are bolted, wired, and framed in place.
Here the amps are all finished and all wiring except subs wires are connected and hidden. The switches along top of the trunk are for strobes and neon. The meters on the sides of the switches are for the capacitor voltage (same as interior volt meters). The strobe controller can be seen in the upper left corner of the trunk above the power distribution block. The right side of the trunk near the top houses the ground distribution block.
A behind the scenes look.
Almost done...just add subs.
The completed system!
Dual chrome fire extinguishers
Custom trunk lid insert
Power and ground distribution blocks
Capacitor shot
Before and after the insert fabrication
Making of the ZX2 logo
Panasonic head unit
Kenwood door and rear speakers
American Pro 10 inch subs
Pyramid amps
Monster Cap capacitors
Scorche wires and distribution
