Injen Cold Air Intake (Removed for Supercharger) - Took about 2 hours to install. We did have to remove the front bumper and drivers side headlight, but that isn't hard at all. We used a Stant Oil Filter Cap #11072 to plug the air pump hole, since it wasn't used. The cap is rubber and seats tight, so no air leak. We can defiantly tell a difference in throttle response. We used the RD3020 with a black finish. Injen has just rated this intake as fitting the new 02-03 VR6 24 valve engines. This intake also is stamped as CARB Approved for the earlier models. The dyno was a maximum gain of 10.2 hp and 8.8 torque.
Bosal Stainless Steel Cat-Back Exhaust System - One great looking and aggressive exhaust system. Doesn't have a loud popping sound, but a deep note and quiet at idol. We had a dyno done the week after the install and found we gained 9 HP and 8 torque.
