Here is my license plate and and license plate frame on the lude. Now that I have boost, just need to dyno tune and then we can go hunting.
Pics of Thermo-Tec Turbo Insulating Kit, Exhaust Insulating Wrap, Thermo-Tec Snap Straps, Thermo-Shield, and Thermo Sleeve. Ricky from Murray's Speed & Custom provided quality service and advice. 12620 North Kendall Drive. Miami, Florida, 33186. 305-271-5848. The turbo manifold and downpipe was the hardest to wrap. I got alot of cuts and scratches wrapping them. Thermo-Tec Snap Straps helped hold the exhaust wrap in place. Using them made the installation easy because they were simple to use. But be careful if you use them because they can give you a nasty cut. The Themo-Tec Black Hi-Heat Coating Paint protects the exhaust wrap from oil, gas, & grease. It helps the exhaust wrap to withstand 2000 degrees F continously. After putting on all the Thermo-Tec products, the underhood temperture has dropped drastically. My A/C cools much better since I wrapped the A/C lines with the Thermo-Tec Shield.
Suspension upgrades are Neuspeed Race Springs, Koni Yellow Adjustable Shocks, Neuspeed Front and Rear Sway Bars, Neuspeed Front Strut Bar, Another Front Strut Bar also (the neuspeed bar bolted to the frame of the car while the other bar bolted to the shock towers, i was lazy to take off the other bar so i left both of them on), Cucso Rear Strut Bar, Energy Suspension Hyper-Flex Kit, Energy Suspension Rear Trailing Arm Set, Ingalls Front and rear 1.25-3 degree camber kits, H&R Front and Rear 15mm Wheel Spacers. Tanabe Front and Rear Under Braces just installed. Suspension is 100% complete. Running on Bridgestone Potenza RE750 205/50/15 Tires. I have got a peak reading of 1.32G's on my Apexi Rev/Speed Meter. Not bad for a stock looking car.......making it look simple with superb abilities! Vince @ V & M Automotive INC. did all the major suspension upgrades. 10330 S.W. 187st. Miami, FLorida, 33157. 305-251-1096.
Pics with 15mm spacers in the front and the rear.
Pics of the lowest point under the front and back of the car. The front Tanabe Underbrace is 2" from the ground. I have already dragged a couple things down the road. Magnaflow Race Series Muffler with 3" mandrel bent piping done by
Miguel at Miami Muffler, 10530 SW 185th Terrace, Miami, Florida, 33157. 305-255-7704.
Got a base run on the
AWD Dyonjet. 145.8hp@5400rpm & 149tq@4500rpm. Need to dyno with the turbonetics kit now.
For all you guys in Miami this was done on the first and only 4 wheel drive dyno in South Florida at Twilight Performance, 537A Burlington Street, Miami, Florida, 33054. 305-769-0140.
