Round 3 Mods...
I started off round 3 with an LS1 driveshaft.
I then bought Motive 3.73 Gears and T/A Rear End girdle
I also installed BMR Non Adjustable LCA's when I did the gears. Big thanks to Terence for carrying the work load!
Next I added MSD 8.5mm Superconductor Wires and an LT4 Knock Module.
The last 2 mods were ASP underdrive/overdrive pullies and an Accel 300+ Ignition box and Coil.
I then went to New England dragway on 4/02 and ran a best of
60' 2.14
1/8 8.69
mph 83.50
1/4 13.38
mph 105.78
Next I headed back to the dyno, but a different one. On 6/02 I went to New England Dyno in Worcester, MA and rolled onto their dynojet. The temp was in the 80's and the gears were also added compared to last time. These 2 factors plus small inconsistencies between different dynos resulted in the following:
295rwhp @ 5300rpm
325rwtq @ 3900rpm (-6rwhp/-13rwtq from the previous round)
