Casey's 92 Integra
Thank you for Viewing. Leave comments and I will return all.
The Front- bumper is drift. I didn't mold it in like the rest of the body kit so I could remove it for towing. I had to cut it in half to size it and make it fit properly, SO BEWARE. The headlights I bought on Ebay from member yishiau. They are 1pc. projectors w/ dual halos, black model. Mine has a clear side reflector inside of orange like most that are being sold. The paint so Acura NSX SI blue and Escalade Diamond White and a white primer to make the flakes pop.
The Side- Molded in skirts. Shaved handles w/ poppers by AutoLoc. GT Factory Lambo doors. The door kit is awsome, they are fully adjustable but are a weld on kit. I have to say that I am very impressed with the install though. I haven't seen any Tegs w/ door that go as high or open out as far as mine. "bragging" The wheel I have upgrade to chrome as shown on other pics.
The Rear- Molded in bumper. I had to custom make the licence plate box. Supra taillight conversion. The key hole in the taillight is rigged to operate trunk latch as I Shaved the factory Teg key hole. Also is the only way to get into my car if the batteries are dead. Molded in rear wing.
1st Place at 2006 NOPI South Georgia in the Sport Compact Acura Custom Division.
On the dash under the hazards is my speed juice master and a purge button.
Leather seats are from a 3rd gen Teg. JDM center console which I have redone to leather since this picture.
Added the 3 toggles on he dash for my interior blue lights, undercar multi color led lights, and on/off for the 2nd battery.
Autometer Cobalt gauges 5" Monster Tac w/ blue shift lite, Elec Oil Pressure, and A/F Ratio gauge for looks.
Found the rear leather seat in a junk yard and paid $50 for, which return to excellent condition.
Custom Sunroof that pops up and then slide back.
This is the wire job I did for and the extra electronics and mounted to the drivers underdash kick panel. It took me a day to figure out and wire, so I thought it was picture worthy.
This is the electronics and wiring for the dual batteries and sound system. I installed a solenoid for the 2nd battery to turn it on/off from the dash or a hide switch outside the car.
Sound system is still in progress. I intend on stealing a couple of ideas from fellow Car Domainers and will give props to them when finished.
Custom cut head cover to show the cams. Engine is stock B18A crate from Jasper. Intending to boost it.
Restore / body work
