For Sale: 1996 Eagle Talon TSi
6000 OBO
The stock 7 bolt went out on me...spun a rod bearing. That's cool though, it was replaced by a 6 bolt engine out of a 1991 Eclipse GS. It's a N/T Block drilled for oil squirters.
Block .020 over
1995 .020 8.5:1 Pistons on 1G Shot-peened Big rods
Mitsu head gasket
Mitsubishi Piston Rings
Clevite 77 Rod and Main Bearings
ARP Head Studs, Rod Bolts, Main Studs
1G Oil Squirters
1G head from 91 GVR4
1G Intake Manifold
2G Exhaust Manifold
1G Throttle Body with 2G Throttle Body Elbow
EGR Removed and block-off plate installed (charcoal canister removed)
Vacuum lines eliminated w/ exception of a few (ex. FPR)
6 Bolt AWD Flywheel
ACT 2600lb Pressure Plate w/ Street Disc
Hall-Effect CAS
Small 16G Turbo
Hallman EVO Manual Boost Controller
HKS Type-1 Silver Turbo Timer
Autometer 30-0-35 Boost Gauge
Redline Fluid in center and rear diff
Pennzoil Synchromesh in tranny
Havoline 10W-40 during breakin
1G BOV
SS turbo oil feed line
90 oil filter housing w/ external oil cooler
Prothane motor mounts
Walbro 255 lph HP Fuel pump
SS fuel line w/ Earl's inline fuel filter from pump to rail
New Kumho Ecsta Supra 712 Tires
MSR Wheels....were on the car when purchased
Symborski Shift Kit w/ CNC Brass shift cable bushings
KYB AGX Struts and Eibach Prokit Springs all around
Driver side and passanger side lower lateral arms replaced at Mitsubishi
Driver side front axle replaced at mitsubishi
The A/C compressor fried itself and seized so I removed it and the bracket from the car. I will include it when the car is sold and a box of other items that can be used on the car. There is a new oil cooler installed oposite the side mount intercooler in the air port. New slave cylinder, new Toga High Volume Oil pump, new mitsu water pump, new Mitsu timing belt, new Gates Alt and PS belts, new accessory belt pulleys, head and block recently machined so are clean and spec'd. 1G rods were shotpeened, cut for roundness, and fit to 2G 8.5:1 compression pistons. If I remember anything else I've done I'll post it on here. If you have any questions let me know.
