1983 D-150
Engine: slant 6 225C.I.
Carb: 2bbl Carter (disconnected charcoal canister)
trans: 4spd O.D.
body: long box reg. cab
how it looked when I bought it early march '09. Yes, i bought it at night. Best decision i<ve ever done. didnt need anything to pass the Ontario safety check and it's too old for a emission's test :)
still working on some bugs... and tunning it. what i've done so far is preatty much covered the bench with a blanket, homemade plywood tool box (found it, i didn<t make it) and put the right size rear tires on her. And the hammer is because the previous owner had the ornament stolen (and one of the emblems on the side), and being a carpenter, i have a few laying around.
the interior is all original with except for the rubber floor mat (even the rips in the bench seat. i have a cover, It's just ugly then the seat itself so i didnt take a pic :P
in the near future:
-manual choke, electric fan, temp guage
-full tune up once I get a job
-box rust protection and toolbox (debating between spray liner, and paint with rubber mats)
-some nice waxing to get the nice colour back out
If you have any comments about these or recommendations, please leave me comments I want to hear your side of these.
thanks
Hammer
