chad05gt’s Ford Mustang
“MoOO-tang”

Benjy at Total Performance Solutions http://www.facebook.com/media/set/?set=a.10150103021660415.277605.508795414&type=1&ref=notif¬if_t=photo_album_reply#!/pages/Total-Performance-Solutions/177426118594   Construction ending soon... very soon :) 

302 stroker: Kellogg 4340 steel 3.75" crank, Manley forged H-Beam rods, CP 2618 alloy pistons, file to fit moly rings, performance main/rod bearings, ARP main studs, balanced & assembled. 9.3:1.  67mm , GT500 pumps, 80lb inj, eBoost2, built TR6060, billet oil pump  gears, pnp heads, inconel valves setup for heat/boost, Comp 127300 cams... Meth...  

Cobra Jet springs, strut tower brace, Roush front sway bar and end links, Steeda rear sway bar and end links, lower controller arms and LCA relocators, rad support, K arms, a arms, poly motot mounts, race adj. upper controller arms,  adj. QA1's rear, D-spec's in front.

N/A pulling the tire! 

@"NMRA Houston '09

1

12.07  w/ DA 1500

http://www.youtube.com/watch?v=xM-E7bxTPqg

117mph trap speed (2)

http://www.youtube.com/watch?v=WXE9cOe2kUA

http://www.youtube.com/watch?v=nXoBbC1KbC4

http://www.youtube.com/watch?

New times!!  12.09!!

splitter going on this weekend :)  pics SOON!!

Heading to Sealy, Tx to run 60-130et July 18th... will update then.

Get ready for texas Mile run in October :)

http://www.youtube.com/watch?v=H3RmNbYGzyU

TR6060 tear down/rebuild :)

Dynotuned by Cody at StangHI  364hp/342tq  peak rwhp @ 6350 RPM, peak tq @ 5000 RPM { 12.5 a/f  }

C&L 95mm vs. Steeda 90mm CAI dyno

Parnelli Jones facia and 15x8 JEGS Pro Stars w/ 27x10.5x15 M/T Streets homemade cut outs  :)

Pics before oil separator..

Livernois Stage II Heads, Comp VSR Stage II Cams, Comp Phaser Limiters, 39lb inj., TR6060 6 Speed, STEEDA tri-axe, RAM Billett Steel Flywheel, RAM Powergrip HD Pressure plate w/ 310 clutch, Spydershaft, 4.56 Gears, STEEDA CAI, Hooker longtubes, Bassani X, no cats, Magnaflows.  { port matched from throttle body to headers :)  }

http://www.youtube.com/watch?v=0r_8yTklKew&feature=related

STEEDA:  springs, strut tower brace, front sway bar and end links, rear sway bar and end links, lower controller arms and LCA relocators, rad support, K arms, a arms, poly motot mounts, race adj. upper controller arms,  adj. QA1's, Cobra Jet springs.

Concept functional ram air hood, powerslot rotors, ADR M-Sport 19x8.8 front 19x9.5 rear with  g-Force T/A KDW 2 275/35 front, 325/35 rear. { Saleen Heritage front facia being prepped for paint :) }