Ok this project is for my Tahoe lovers of the old style body ..




Ok there were a few wires i needed to splice into eventhough i used the 6017 painless wire harness and comp. this one here is spliced into the speedometer so i know how fast i'm going.
this wire was a jumper that was spliced into the speedo and cruise control
THis wire went to the new computer labeled as VSS output
ok if your going to do the swap make sure you got the Battery quick disconnect that goes with the engine

top view

passenger side view

new comp held in place by my spotty weld job on the bracket i made for it
OK here is the pick of the flange i took this pic because S&P says it bolts right up but for me it didn't my flange was a lot smaller than the flange that bolted up to the manifolds. So maybe it does but for me it didn't so i had to cut my exhaust then have it done by the pros which did a great job by the way..
