Here's what it looks like right now. I started with a cool setup in mind, but decided that it probably isn't what I want, so another box is being built right now. The next box as seen above will have the subs will fire into the rear seats, and there will be a plexiglass panel on the back of it, allowing you to see the magnet.The amps are mounted in an amp rack that is bolted down. (As see in the picture at the top.) Plexiglas covers them, and there are fans on either side. More info on that to come. The plexiglas needs to be replaced after it got scratched up by a loose tape-measure sliding around in the trunk.CDT Audio components.4" mid with 1" tweeter4" stock opening, and had to cut a hole in the upper portion of the door (NOT EASY with just a Dremel!!)CDT Audio rear fill: 5.25" 2-waysHad to cut holes in bottom-rear corner of the doors to mount.As for wiring, I went with 4 gauge monster cable power and ground wire. It is fused under the hood with a 60 amp fuse. I used gold plated/shielded interconnects, and 12 gauge speaker wire.Check later for future progress.Go onto page 3 for more info on the box.