Battery Relocation : I been searching everywhere for a proper guide to relocating the battery on the Max so I decided to do my own little write up just in case anyone else wants to do this... I know you can make your own kit from junk you find at your local parts store but I just ordered the kit from summit and paid the 80 bucks, saves me gas and time and I just like getting stuff in the mail.. PLEASE READ EVERYTHING BEFORE PROCEEDING and i'm not responsible for your mistakes so read carefully, use intelligence and be aware that your messing with your cars electrical system, You can blow fuses, fry the ECU and cause a fire so please be careful. Battery Box from summit. Packaging. Everything included. Open trunk, all doors, and disconnect positive cable . Starter and fuse box on positive cable . Both connected to fuse . The blue cable is my subwoofer positive wire, just pretend it's not there; The negitive screws into the body and attaches to engine ground. Remove battery terminal connector from wires. 120 amp fuse Remove screw from battery terminal holder. Pry open terminal battery holder. Put back the positive terminals as they were and put the screw you just got out of the battery terminal and put it through hole and attach the nut. Time for break... I'm hungry...Go eat... Open fender liner on drivers side and you will see two holes... One goes up into the engine and the other is used by your hood open wire that goes inside the cabin, I used my sub wire and taped them together to pull it through so I didn't have to take off my fender liner. Pull out floor panel and run wire, I used a little tape not shown here to make it a little neater. Push it under middle section and rear floor panel and under the seat at the side and right into the trunk. Replace floor panels front and back. Put battery in box and connect the ground wire and I have no idea how but there was a little hole which I didn't see but when I pushed my finger against the felt to make a hole for the wire my finger just went through so just make one if it's not there and use the screw from the bag that came from summit and find a hole to ground the neg wire. Connect positive wire between starter and fused connection and put on screw and nut from earlier. I just taped up my neg cable end until I can get to autozone to cut it off and crimp on an end that I can ground to the body somewhere. Finished.