It's a pump gas 306, The engine has a Saleen intake, 24# injectors, Cobra mass air meter, 70mm Accufab throttle body, Edelbrock Aluminum Performer 5.0 heads with light amount of port work, Lock wire head gaskets, MSD ignition, Mallory 2 step, FRPP 1.7 Roller rockers, Lunati Hydraulic roller camshaft 230/240 @.05 with around .530 lift, Light weight TRW pistons, Stock block, crank and rods, Mac long tube stainless steel headers, 3" X- pipe to a pair of Dynomax Ultraflo mufflers, Autometer gauges, 100 shot NOS wet kit. Trans: Tremec 3550, PRO 5.0 shifter, Lakewood bellhousing, Spec Aluminum flywheel, Spec stage 3 clutch, Hpm Cross member, HPM driveshaft safety loop, Aluminum drive shaft. Rear Axle: 8.8 with 31 spline Moser axles, 31 spline limited slip, 3.73 ring and pinion. Suspension: Front - UPR tubular K-member, UPR tubular A-arms, UPR caster camber plates, UPR coil over kit, Lakewood 90/10 struts, QA1 coil springs. Suspension: Rear - Hpm Mega bite lower control arms, Edelbrock double adjustable upper control arms, Lakewood 50/50 rear shocks, Hpm sub frame connectors, CCM Fabricated 3/16" steel Torque boxes.