Installing Dual Exhaust

Step 1: Go to your local Dodge dealership and order the rear SRT8 bottom fascia.  It arrived in 4 days for me and cost $73 with tax.

Step 2: Go home and let the car cool off! Get your tools ready as well.  You will need a 8mm socket and a right pick tool (or something with a pointed right end).

Step 3: Remove the 2 pins holding in the rear fascia on each side, they are located right behind the tire, there is a big one in obvious sight and a smaller one that you have to peel back the wheel well to get, if you look under the car at the fascia you can locate them no problem.  To remove these pins, use your right pick tool to press the center down until it pops inward, then reach your hand behind and straighten out the clip and push it outward.

Step 4: Remove the two 8mm nuts near the center of the rear fascia.

Step 5: Snap out the 3 clips on each side of the fascia and in the corners there is a pin in each corner, pop those out and continue on to popping out the rest of the clips. The pin on the side of the exhaust is tricky to get to, but it is possible to get out without removing anything. I found it easiest to sit facing the rear bumper and to press forward on the bumper and outward of the fascia.  Once the fascia is off, put it aside and put your new one under the car.

Step 6: Line up the new fascia and re-bolt the two 8mm bnuts that were removed, DO NOT TIGHTEN YET! Now pop in the 3 side clips on each side, then procede to clip in the rest of the clips along the back of the bumper, you may have to move it side to side to make sure the clips line up with the hole 100%.  Once all the clips are in, tighten the 8mm nuts, and put the 4 side pins back in.   *I did not install the corner pins, they were too much of a hassle, you can not notice a difference without them, so it is up to you if you want to put them back*

Step 7: Take it the exhaust shop and tell them what you want :woot:

Cold Air Intake

I went with the Big Bully 3.5L Intake, and I love it and it looks great.