Process continued..... to make the horn work, takes a little thinking to accomplish. I figured out how to make it work.First, make ur steering wheel horn button wire connections onto the quick-release. Next part is tricky, the wires that come up the SRS harness, one of the wires is for the horn, which is has the 12V (positive side). My case was the blue wire with a thin red strip. You can either cut and strip the wires to expose about 1-2 inches of wire, or try picking the wire out from the connector. I cut and stripped.Next, I glued and taped the exposed wired long enough to touch the back (gold plate side) of the hub adaptor. see picture below. Install the hub and tighten. The hub has two wires, connect them to the quick-release separator, that attaches to the hub. Don't worry about getting the wires reversed because it's a male-to-female connection (u can't mess up). Also, don't worry about attaching the Negative side of the wire on the hub because the Steering shaft is the ground. Attach the steering wheel and test it out!