Posted by: doublec4

07/28/2009 09:07AM

The holes were drilled by the body shop but I would imagine they took measurements or maybe through some marker on the end of the bolts, placed the wing where it would sit so the marker gets on the decklid and then drill those spots

Posted by: doublec4

07/27/2009 05:53PM

Hi Brian, I mounted my wing with bolts. The bolt heads were fiberglassed into the spoiler and then holes were drilled into the deck lid. I slipped the bolts through the holes, through on some nuts and away I went. It required some small rubber spacers though

Posted by: impalacj

07/09/2009 12:07PM

very nice clean looking car

Posted by: ub3rduck

07/08/2009 08:08AM

Hey, nice fiero! I actually went to a U-Pull-it junkyard and got a spare center console from a junk fiero. I ripped all the covering and foam off of it and just used the base plastic from it. Then I just built my support and fleeced it from there. I tried making a base out of cardboard and fiberglass but I found it 100 times easier to just use a stock base. If you haven't already, check out fiero.com. There's lots of people doing some sweet custom stuff to their fieros and they could give you some good ideas to build on.

Posted by: FieroMatt

03/21/2009 05:35PM

hey i own two fieros and 84 se converted into an 85 gt with a 350 in it and also so far a pretty stock 86 gt. i just was wondering if you had any pictures or advice about how you did your cherry bomb instalation because i love the sound of cherry bombs and has hopin to put the glass pack into my 86. thatnks alot -matt