This chassis is a 1991 Nissan 240SX Hatchback.

On or around July 2008, I began tearing the car down, which was completely stock at the time. Its a tedious and hard job, but its recommended to build a powerful and competitive drift car.

Started by tearing out the stock interior, down to the bear metal. Once all that was removed, I proceeded to get the black sticky tar, otherwise known as the sound deadening, out of the car as well. If you ever run into this, I recommend using dry ice, break it up and spread it all over the sound deadening, once it hardens you begin to chisel it off the metal of the car.

The car also had tint on the windows, so that had to come off as well.

Air conditioning and Heating units were removed.

As for the engine bay, the stock KA motor was immediately ripped out. Now, just like all old and beaten cars, the engine bay had tons of oil and mud caked all over the place. So many hours of scrubbing and washing was put in to get the engine bay nice and clean. Especially ready for paint.

The car should put down around 270-300 horsepower to the wheels. Hopefully, once its all said and done. Maybe more, if I acquire some engine components to put it safely at 350HP.

Here's a list of the car's current parts:

Engine

-SR20DET (Blacktop)

-Bulleye Power T04-B Turbo

-Custom Manifold

-Blitz Air Filter

-Spearco Intercooler

-Tomei Fuel Regulator

-Nismo Thermostat

-Nismo Engine Mounts

-Custom Intercooler Piping

-Oil Cooler

-Samco Coolant Hoses

-Steel Braided Clutch Line

-Oil Catch Tank

-Greddy Oil Pan

-Spal Radiator Fans

Transmission

-ACT 6-puck clutch

-Nismo Transmission Mount

Suspension and Brakes

-Tein Inner and Outer Tie Rods

-Tein Tension Rods

-Battle Version Toe Rods

-Battle Version Traction Rods

-Battle Version Rear Upper Control Arms

-Stance GT+Pro SS-D Coilovers

-Z Brakes

-Brembo Rotors

-Project Mu Brake Pads

Interior

-Momo Super Cup Seat (Driver)

-Momo T-Club Seat (Passenger)

-Momo 6-point Harness (Driver)

-Momo 4-point Harness (Passenger)

-Vertex Deep Dish 330mm Steering Wheel

-Steering Wheel Quick Release

-Stack Gauges

-Custom 6 Point Roll Cage

-Alpine CD Player

-Infinity Speakers

-Apexi Rev/Speed Meter

-Greddy Boost Controller

-Apexi AFC-R

-Bride Seat Rails

-Aluminum Battery Box

-Yashio Factory Drift Knob

Exterior

-BN Sports Knock off Full Aero

-40mm Rear Over Fenders

-D-Max Front Fenders

-PIAA Driving Lights

-PIAA Fog Lights

-Kouki Tail Lights

Most of these parts are not installed on the car right now.

The engine bay freshly painted.

The engine bay is the only area of the car that will have that color.

Fitting the aero.

The motor finally mounted in the car.

Thanks for looking! Check back often to see the progress on the car.