Vehicle Owner

Member ID: theredV8eater

Location: price, UT

Vehicle Info

1991 Eagle Talon

Bragging Rights

  • 1/4 Mile0 sec @ -1 mph
  • 0-600sec
  • Top Speed-1mph
  • HP-1
  • Weight-1lbs

Major Upgrades

  • turbo
  • nitrous
  • bore increase
  • port and polish
  • supercharger
  • extrude honed
  • stroke increase
  • engine swap

Modifications

Performance Parts

Interior

Exterior Styling

  • Catz Lighting 
  • Falken Tires 
  • ALT Wheels 

Car Audio & Video

  • Pioneer Video 
  • Boss Wiring 

Ratings

    • Currently 3.3/5 Stars.

Login to rate

 

Last updated: Jul 28, 2008

Hits: 730

Cjay’s Eagle Talon

  • Currently 3.3 /5 Stars.
4 guestbook comments

This is my 1991 eagle talon awd tsi.

theredV8eater's 1991 Eagle Talon


i bought the car for $800 three years ago. the car has ben a work in progress, just recently the tranny went out. and i will be putting in a shepherd racing tranny in it by this fall.
ENGINEtheredV8eater's 1991 Eagle Talon
6 Bolt block 20 Over, O-ringed.
Crower I-Beam rods
Hrc Big 16G turbo.
5G hks bov.
JM Fabrications Sheet Metal Intake Manifold
Venoila pistons 7.5
ACL Bearings
Supertech dual valve springs
"FP3" Intake Cam
"FP3" Exhaust cam
AEM Adjustable cam gears
Exhaust.
T3 / Mitsubishi Turbine inlet adapter plate
FP Race Exhaust Manifold
Tial 35mm external wastegate
3" downpipe
3" straight pipe.
3" cat back.
last time we dinoed it was like... 3 months ago and it had 368awhp and 430lbtq
and this was before the exhaust system and the 550cc injectors.

theredV8eater's 1991 Eagle Talon


Guestbook

Displaying entries 1-4 of 4

1darktalon  

Posted by: 1darktalon

08/06/2008 11:11AM

man that is a bad ass car congrats check my 2g sometime

Grand-AM-SE  

Posted by: Grand-AM-SE

08/01/2008 06:03PM

Ya i have adjusted all the cables because when i got the car the shifter cables were streched so i had to replace them. But i might get a new tranny from shep racing because i drove it around the block the other day and i think the second gear syncro is bad. Or i have more adjusting to do. But nice car keep up the good work

PunkerDannyW  

Posted by: PunkerDannyW

07/28/2008 02:26PM

The mods to the motor so far are a short ram air intake, 10.2 mm spark plug wires, iridium plugs, grounding kit, light weight underdrive pulley, msd ignition, and a klze eprom chip. I have a supercharger and an intercooler...but i haven't put it on yet.

PunkerDannyW  

Posted by: PunkerDannyW

07/27/2008 11:11PM

Super clean ride you got there. Dropping you 5 stars all the way. Check out my ride and throw some stars my way. Keep up the great work.

Show Older Comments

Post a comment

Bookmark this Ride

Vehicle Owner

Member ID: theredV8eater

Location: price, UT