1998 Nissan 200 SX SE-R (2 Door Coupe)

1st Page - My Car Log [ [ [---YOU ARE HERE---] ] ]
2nd Page - My Motor
3rd Page - My Exterior
4th Page - My Interior/Upholstery
5th Page - My Audio System
6th Page - My !!!NEON!!!

July 4th 2008
Riding down the road, I happened to glance to my right and there I saw a red Nissan 200 SX SE-R sitting in a Auto Zone parking lot, windows full of contact and vehicle information. I take down what I thought was the correct number. About 2 hours later I called that number, the operator said it was disconnected, hmmm, a person trying to sell a car with a disconnected contact number? I think not, so I ride back by the car and get out this time (LoL). I take down the correct number this time and call. The guy meets up @ the, I test-drive it around and it starts jerking in 2nd gear, are you kidding me? The guy says he never had trouble with the car before, that it might be the spark plugs and or wires and that he would take it to the shop and find out what was wrong with it.
As luck would have it, it was the fuel filter, which wasn’t in the best condition.

July 6th 2008
The car runs fine, how do I know this? Because I bought it LOL.

July 8th, 2008
I installed my audio system which consists of a Dual 220w Head Unit, 4 Infinity 225w 6.5's, 2 tweeters (forgot brand), 2 Kicker L7 Solo Baric Sub Woofers in a center ported box, A Lanzar Vibe 4000w Amplifier (for the Solo Barics), and a Pyramid Crystal 1000w Amplifier (for the 6.5's).

July 13th 2008
I replaced my back brakes, I didn’t know my back breaks required pressure and turning to make the brake piston go back into the caliper, I thought a regular C-Clamp would push it back inside, WRONG! Then after I removed the piston and seen the threading, I thought just turning the piston would make it go back in, WRONG again! I went to Auto-Zone and rented a kit that solved my simultaneous pressure + turning problem LoL. I replaced by back brakes because for some reason the brakes on the rear passenger side would start smoking after driving the car. After removing the brake pads I realized that the outer brake pad had worn at an angle instead of flat.

July 14th, 2008
I bought some used rear tires. The rear driver side tire had wire showing (bad juju) and the passenger side tire wasn't far behind.

July 16th, 2008
I replaced my front brakes, they didn’t look that bad but I just wanted to replace them all around the same time.

===========
===========
===========
===========