This is my first brand new car.
2008 Nissan Sentra 2.0S
6 Speed Manual Transmission.
No the fastest but it definately has decent power.
I'm concentrating on the exterior mostly until more performance parts are available.
I'm looking for a set of 07-09 SE-R front seats only if anyone has them for sale.
My goal is to buy something for this car every paycheck, next mod being the SE-R spoiler.
Please check it out and leave me some comments.
I<3Nissan
After A Nice Waxingg =)
Tails Smoked Pitch Black And Rear Debadged
I Decided To Rock The Steelies Until I Get Some Rims =)
Fresh Outta The Car Wash, GLEAMINNN, Good Shot Of The Steelies haha!
I Think I Need Some HID's, What U Think??
Removing The Door Panel To Install New Infinity Kappa 6x9's =)
The Kappa's Side By Side With The Stock, Huge Difference..
Kappa Installed In The Door
Kappa's Installed In The Rear Deck
Yes, It Was Ridiculously Hard To Install The Rears..
A Shot From The Trunk, These Sound So Beastly..
A shot of the 6 spd
I had a Minor OPPS, im getting an OEM headlight and fender for now. As for the bumper, the new AIT Racing bumper cover should fix this problem :). Should be installed in about a month.
My new headlight and fender came came in, just need to install.
Still working on the bumber
Got the bumper and headlights taken out. (Why didn't someone warn me how hard the bumper is to get off WOW!!) haha
Old fender taken off
New fender installed. When I put it on, I realized how cool the matte black looked, I think I may have the whole car done in matte black
New headlight installed. Now I'm just saving up for the AIT Racing bumper cover.
A quick bath after I was finished fixing her broken nose.
Center dash trim will soon be custom fiberglassed with a 7" monitor and gauge bezel. I'm also having a custom fiberglass center console and door panels made.
I decided to start fiberglass some of the trim pieces that I could do by myself.
Started out sizing up how much fiberglass matte i would need and cut it out.
After that I took a sharpe and outlined the edges to get a perfect fit.
Then I sanded down the piece real good and washed it with soap and water.
Mixed up some resin and coated the part and the matte and laid it down.
Let the resin dry and sanded it down again reallllll good. About 2 hours of sanding.
Minor imperfections to be fixed with filler :)
