expand

Daihatsu YRV

SQ System build in progress.

Day1
Stripdown and repair of previous owners upgrade.

Dashboard.

expand

The mess of the headunit wiring.

expand

Standard door speaker grills

expand

'upgraded' Kenwood speakers fitted by preious owner lol.

expand

Standard width of front door hole. Im sure that will need a bit of trimming.

expand

Available depth in the front doors.

expand

Rear speakers, I thought i better check out what mess they had made of the rear doors after seeing the fronts.

expand

After removing the rear speaker. They tried fitting speaker with 145mm width in 130mm holes.

expand

Front door speaker and kick panel shown, quite a bit depth in the kicks by the look of it.

expand

expand

Drivers side kick panel.

expand

Standard Dash 4" midrange units.

expand

expand

Standard Boot(trunk).

expand

expand

Day2

Car frequency response measurement day &
Double check of the tape measurements of locations to decide what equipment to use.

After much thought and analysis of the results the following will go into the car.

Nakamichi CD-700II (Headunit)
Alto Mobile UCS pro (EQ & processor)
Genesis profile two ultra (Left midrange & left tweeter amplifier)
Genesis profile two ultra (Right midrange & right tweeter amplifier)
Genesis profile sub (subwoofer amplifier)
JL Audio 12W6v2(12" subwoofer)
Xetec P6 (scanspeak 15W & 6000 based drivers) in the kick/a-pillar.

Day3

The plan for day 3 is.
Cutting out of the kickpanel for the midrange driver and fitting of dynamat.