ok to begin with i would like to say that without the help of my good friend joe n and bob c this jeep would be in a big pile still...thanks guys
ok so i bought a 88 yj its frame was really really bad so i got a new one then the tub was to bad to fix so i bought a whole new parts jeep and now its time for the rebuilding process
new MODS so far
clutch
4wd suspenion lift & shocks
1 inch daystar body lift
cragger steel wheels 15 x 10
mickey thompson baja claw 33 x 12.5 x 15 tires
warrior products full rear corner panel gaurds
no lift greasble currie front and rear shackles
pacesetter header
timeing chain and gear
shaved my flywheel down some
rubber valve cover gasket
rubber oil pan gasket
front main seal
rear main seal
water pump and seal
theamostat and seal
the seal inside the trans around the shaft
did the nutter by pass with the carb
bypassed the whole computer
changed the front and rear axles 4:10s now
lots and lots of new paint
took apart almost all the wiring harness
near future mods ( couple of weeks )
custom made rocker guards in black to match rear corner panel guards
fresh paint (kawasaki green)
new bigger carb
custom 3 inch exhaust and muffler work
6 inch wide xenon fender flares
slip yoke cv drive shaft
yukon replacement axle shafts
richmond locright front locker
not so near near futur ( this winter )
finish the body work not just cover up with sheet metal and bondo real panels put back in
new custom fresh paint with clear coat
rear bumber/ tire carrier
winch bumber and winch
this is the parts jeep its a 95

just takening her apart

just the just frame left over man was it bad

newer frame from a 92 tires rims some motor work being done

new clutch put in tranny work being done lots of new seals and gaskets