I am new to Cardomain but I am planning to add some pretty cool stuff to my 1999 Dodge Ram 1500 5.2L. It is 2WD and has the 8ft bed. It only has 59,800 miles!!!!! Please Rate !!!!!

I just bought a new alarm system with paging remotes, air pressure sensor,tilt sensor,motion sensors, galss breaking sensors,key pad starter kill, and backup alarm horn so that if they cut  alarm wires and horn wires the back up horn will go off until you turn it off with the key.

!!!!!!!! 10 12" SUBWOOFERS!!!!!

I have 4 12" Jackhammers 250 watts rms each and 500 peak hooked up to a BOSS DD2600 amp that puts out 900 watts rms and 2000 watts peak.

I have 4 BASS series subs that are 400 watts rms and 800 watts peak hooked up to (2) TIS 1800 watt amps that put out 600 watts each at 4 ohms so combined 1200 watts rms.

I have 2 rockford fosgate puch subwoofers with a BOSS 3200 watt amp.

On 11/16/08 I bought 2 12" Kicker Comp subs. (150 watts rms each and 300 watts peak.) Circuit City is closing so they were on sale.

I have a BOSS 10 farad capacitor and a BOSS 20 farad capacitor that are connected to distribution blocks running to all four amps.

A picture of all 12 12's.

 

 

 

 

 

New visonik v2418 600 watt 2 channel amp

I am going to hook this up to my new kicker comps, it puts out 150 watts x2 @ 4ohms, and 300 watts x2 @ 4 ohms max.

New Subs

 

 

 

 

 

This is the toggle switch I installed to turn on my subs.

 

 

 

 

 

 

 

I have (4) four MTX JACKHAMMER and 4 BASS 800 watt subwoofers .

I just bought a BOSS DD2600 amp. It puts out 900 watts RMS at 4 Ohms.

 

I also just bought 2 TIS 1800 watt amps to power the BASS series subs. They put out 1200 watts rms each.

I bought all the wiring I need but I'm building a custom amp rack so when I finish that I'll hook up my new amps.

I just replaced the stock speakers with new ones.

I installed 6x9 Jensen Triaxial Speakers in the doors. These are 80W RMS and 400W peak.They have a 13mm tweeter for crisp high tones and a 45mm midrange.

 I installed 5 1/4 Sony X-Plod 4 way speakers in the rear.

Woofer: 13cm (5 1/8") cone type

Midrange: 3cm (1 3/16") balanced dome type

Tweeter: 0.8cm (11/32") dome type

Super Tweeter: 1cm (13/32") dome type

Peak power: 160W

Rated power: 35W

 

Here are the pictures of my dash painted white.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

This is a picture of my 318 5.2L V8 Magnum engine. On 8/27/08 I installed a new performance chip that will give me 100+ extra horse power and up to 70 ft lbs of torque. I just installed my new throttle body spacer and this should give me up to 30+ hp and 3-5 more mpg.

 

Before Cold air intake:

New custom powdercoated white cold air intake.

 

 

Here are pictures of my throttle body spacer installed.

This is my custom windshield decal I ordered from www.signsspecialist.com (White with a charcol gray shadow)

These are my new white dual blade windshield wipers.

I unbolted the center seat so that I could have bucket seats but the brackets for the center seat are welded to the driver and passenger seat so I need to grind off the welds.

These are pictures of the passenger seat with the middle and driver seat removed.(I have already taken off the middle seat mounting brackets.)

 

Here are some pictures of the driver's seat with the brackets removed.

 

 

 

Here are some pictures with both seats in and center seat removed.

These are pictures of me installing my neons that I bought from ledunderbody.com: It came with 4 9" red tubes with 30 LED's in each tube. On the controller there are different solid color and flashing effects to chose. The best is the sound mode, which means the neons flash to the beat of your music.

 

 

In order to conceal all my wiring I ran the lights that go under the seats underneath the carpet.

To make sure I did not drill into any wires I had to remove the knee blocker panel underneath the steering column.

 

I hid the extra wire inside of the airbag conrol unit panel.

Here are pictures of my neons installed.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

These are some random pictures I took in my garage after I installed my neons.

 

This is a Clarion CD player, the guy who owned the truck before had it installed.

I just installed a new starter motor on 6/7/08 because I was having problems with the old one. I also installed a new water pump.

 

 

This is my S.W.A.T. Lock-R anti-theft device with an 130db alarm.

Old Subs
I installed4 12" BASS (Bad Ass Serious Sub(designed for competitions)) subwoofers and a quadruple enclosure along with a 3200 watt Boss amp.
Features:
2” Parabolic RFL Voice Coil
60 oz. Magnet
Oversized Rubber Surround
4 Ohm Impedance
Poly Zirconium Cone
Efficiency / Sensitivity 98dB @ 1 Watt / 1 Meter
Polyimide Voice Coil Former
Mid Q Design for Versatility in Enclosure Compatibility
Flat Progressive Roll Spider
CEA Cooling Technology
Vented and Extended Pole Piece
Low Carbon Top and Bottom Plate
Weather Resistant Design
Approved for Car Audio and Marine Use
3 Year Warranty

 

New Subs

 

I have (4) four MTX JACKHAMMER subwoofers.They are 4 Ohms 250 watts RMS and 500 watts peak each. So all four subs combined is 1000 watts RMS.

This is my quadruple enclosure, it has 1.5 cubic feet of air per chamber so it should produce pretty good sound.

Old amp:

This is my BOSS 3200 watt 4 channel amp.
Features: 4 Channel Bridgeable Amplification
Tri-way Configuration: 1/ 2 Channels
3200 Watts Total System Output
Variable Gain Control
MOSFET Pulse Width Modulated Power Supply
Built-In Variable Subwoofer Crossover
High Level Low Impedance MOLEX Input Connector
RCA Low Level Inputs
Speaker Output Terminal Strip
Signal/Noise Ratio: 90dB
THD Less Than 0.04%
Frequency Response: 15-30kHz
Overload Protection
Thermal Protection
Short Circuit Protection
Power On LED Indicator
LED Diagnostic Condition Indicator
Automotive Type Fuse Protection
Dimensions: 18' X 8' X 2'

 

I just bought a 5000 watt earthquake amp installation kit.

 

This is my old 3.5 farad BOSS capacitor.

 

This is my new 10 farad (10,000 watts) capacitor.